Estimate the theoretical mass of plate, round bar, square bar, hex bar, tube or disc from nominal dimensions and published grade density. Weight drives freight, freight drives landed cost — so get this number before you ask us for a price.
Result is a theoretical geometry × density figure. Actual mass varies with mill tolerance on thickness and diameter, and with any facing or pickling allowance. Verify with the MTC before you commit a freight booking or a lifting plan.
Density is not a specification requirement, so these are not guaranteed values. 1 g/cm³ = 0.036127 lb/in³; 1 lb = 0.45359237 kg.
Get a price on this weight Compare grades insteadMass is density multiplied by the volume of solid metal. For a constant cross-section that means density × cross-sectional area × length, so the only real judgement is which area formula matches the product form you are buying.
| Shape | Volume formula | Watch out for |
|---|---|---|
| Plate / sheet | V = L × W × T | Use actual thickness, not nominal — 6 mm often ships at 6.2 mm |
| Round bar | V = (π/4) × D² × L | Turned bar loses material to the turning allowance |
| Square bar | V = S² × L | Corner radii make this a slight over-estimate |
| Hex bar | V = (√3/2) × F² × L | F is across flats, not corner to corner |
| Tube | V = (π/4) × (OD² − ID²) × L | Wall tolerance at the thin end moves weight by several percent |
| Disc / flange blank | V = (π/4) × (D² − ID²) × T | Set ID = 0 for a solid blind flange blank |
A Gr2 plate at 2500 × 1200 × 3 mm gives 9,000 cm³. At 4.51 g/cm³ that is 40.59 kg per sheet. Twenty-one sheets is 852 kg, which is roughly what one 2.5 t pallet slot takes — so a 21-coil lot is a predictable freight shape, not a guess. The same maths on Gr5 at 4.43 g/cm³ gives 39.87 kg, about 1.8 % lighter for the same volume.
On a 20 t titanium order, a 2 % error in estimated mass is 400 kg — usually more than the margin between a container fitting and a second container being needed. Buyers who estimate from nominal dimensions and then discover the mill tolerance at the port end up renegotiating freight, which delays the project and the payment terms.
Gr1 / 2 / 5 / 7 / 9 / 23 and Ni 200 side by side on chemistry, strength, density and corrosion.
ASTM ↔ ASME ↔ DIN ↔ GB ↔ GOST ↔ AMS by product form, with the disagreements flagged.
Sea LCL/FCL and air indicative rates from Qingdao and Tianjin, updated monthly.
No. It is a budgeting and freight-planning tool. For lifting, rigging or a structural calculation, use the certified weight on the MTC for the actual lot.
The aluminium and vanadium in the alpha-beta structure give a slightly lower packing density than commercially pure titanium — 4.43 against 4.51 g/cm³. Gr5 is about 1.8 % lighter per unit volume and roughly twice as strong.
Yes — Ni 200 and Ni 201 are in the grade list at 8.89 g/cm³. For Monel, Inconel or Hastelloy, choose Custom and enter the supplier’s published density.
No. The calculator runs entirely in your browser, sends nothing to us, and works offline once the page has loaded.