ASTM B265 is a standard specification for titanium and titanium alloy sheet, usually, the tolerance dimensions of titanium plates are determined by the manufacturer during production and provided to customers at the time of ordering. These tolerances can be either bilateral (allowing for both positive and negative deviations) or unilateral (allowing only positive or negative deviations).

For example, a common tolerance specification might be: for an 8mm thick GR2 titanium plate, the tolerance range is ±0.1mm. This means that the actual thickness of the plate may range from 7.9mm to 8.1mm. However, this is just an example, and the specific tolerance dimensions should be based on the specifications provided by the supplier.

During the inspection, you should use appropriate measuring tools, such as digital calipers or block gauges, to measure the thickness of the titanium plate. Ensure the accuracy and precision of the tools to correctly evaluate the thickness of the titanium plate.

During the inspection process, pay special attention to the following points:

1. Preparation: Ensure that the inspection equipment is properly calibrated and the environment is suitable to ensure accurate measurement results.

2. Measurement Technique: Use appropriate measurement techniques, ensure uniform distribution of measurement points, and avoid measurement errors.

3. Record Data: Record the results of each measurement, including the measurement time, location, and the actual thickness measured.

4. Compare Tolerances: Compare the results of each measurement with the specified tolerance range to ensure that the thickness of the titanium plate is within a reasonable range.

5. Note Exceptional Cases: If any exceptional cases are found (such as significant deviations between the measurement results and expected values), report them promptly and take appropriate measures, such as recalibrating equipment or checking the quality of the titanium plate.

In summary, accuracy and reliability are crucial when inspecting titanium plate thickness. By following the provisions of ASTM B265 standard and paying special attention to tolerance ranges and possible exceptional cases during the inspection process, you can ensure the accuracy and reliability of the inspection results.

Shaanxi Qianyi Tuoda Technology Co., Ltd. www.sxqytd.com Tel：+8618829679311

• Titanium product center,China Shaanxi Qianyi Tuoda Technology Co.,Ltd.★★★ Titanium ,Nickel,Titanium Stirrer| Instrument Sensors|Russian Standard Titanium Plate BT1-0|American Standard Titanium Plate Grade2 | Chinese Standard Titanium Plate TA1 TA2 | Titanium Flanges | Titanium Fittings | Nickel Tubes | Titanium Tubes|Titanium Rod| Supplying Stirrer|Supplying Nickel|Supplying Titanium